Black & Decker Battery Racks 2-4 Slot
4 slot wall mount battery pack holder. Fits Black and Decker 20Vmax and clone packs LBXR20, LBXR20B, LBXR20-OPE, LBXR2020, LBXR20, LB20, LBX20, LB2X4020 Not just another battery holder. Designed to make your day easier.
Designed for installation:
Available as: 4 slot, 3 slot, 2 slot
- Mount with 4 or more #8 x 3/4" or longer screws on 3.5" by 1-1/4" spacing.
- Keyholes for screws. Mark holes. Drill pilots, Start screws, slide rack on. Tighten screws. No fumbling while starting screws into wall thru rack holes.
- Rack is better than loose holders. Pre spaced slots. Pack spacing is set by rack and is just right.
- Faster install. Save the time you would loose while working out how far apart to mount the singles.
- Mount racks side by side. Screw holes will be 3.5" apart from rack to rack.
- Pack spacing of 3.5" gives room to hold pack sides during insert and removal.
- Latching slots hold battery securely. Mount them in your work van. Empty that bucket of packs to a wall of beauty.
- Angled slots to present pack and ease handling. Better access to pack latch than flat battery mounts.
- Relief from squeezing fingers between the wall and pack. Find the latch easily.
- Storage cups between packs. Not found with single slot holders. A small bonus of this rack design.
- Prefer non-latching? Cut away latch bar (using wire cutters) to convert to non-latching.
Available as: 4 slot, 3 slot, 2 slot
.jpg)